Difference between revisions of "Colibri PID1"
Jump to navigation
Jump to search
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | Colibri PID is an expansion module with one Pt1000 temperature sensor input and one Analog 0-10 volt output, and an on-board STM32F030 that implements a PID regulator. | + | [[Category:Colibri]]{{metadesc|Colibri PID1 module}} |
| + | [[File:Colibri-pid1-revA-front.jpg|180px|thumb]] | ||
| + | [[File:Colibri-pid1-revA-back.jpg|180px|thumb]] | ||
| + | |||
| + | [[Colibri]] PID is an expansion module with one Pt1000 temperature sensor input and one Analog 0-10 volt output, and an on-board STM32F030 that implements a PID regulator. | ||
MAX31865 is the resistor Whetstone bridge A/D converter. It uses SPI as the interface. | MAX31865 is the resistor Whetstone bridge A/D converter. It uses SPI as the interface. | ||
Latest revision as of 10:49, 20 July 2023
Colibri PID is an expansion module with one Pt1000 temperature sensor input and one Analog 0-10 volt output, and an on-board STM32F030 that implements a PID regulator.
MAX31865 is the resistor Whetstone bridge A/D converter. It uses SPI as the interface.
MCP4725 is the 12 bit D/A converter used.
I2C Addresses
24LC16 = 0x50-0x57 STM32F030 = 0x10-0x1F
MCP4725 = 0x60 ; This is on a separate I2C bus, connected only to the on-board STM32F030