Difference between revisions of "STM32 Scan I²C bus"
Jump to navigation
Jump to search
| Line 50: | Line 50: | ||
0b00011110 << 1 = 60 = 0x3c | 0b00011110 << 1 = 60 = 0x3c | ||
| − | So the | + | So for use with the HAL_I2C commands, shift the address left by one bit. The HAL library will control the read/write bit. |
Revision as of 04:00, 4 June 2021
Scanning an I2C bus using HAL is really simple. First configure I²C in Stm32CubeMX:
Once the I²C has been configured, scanning the bus for slaves become a simple matter:
// Go through all possible i2c addresses
for (uint8_t i = 0; i < 128; i++) {
if (HAL_I2C_IsDeviceReady(&hi2c1, (uint16_t)(i<<1), 3, 5) == HAL_OK) {
// We got an ack
printf("%2x ", i);
} else {
printf("-- ");
}
if (i > 0 && (i + 1) % 16 == 0) printf("\n");
}
printf("\n");
The HAL_I2C_IsDeviceReady will return HAL_OK if it receives an ACK or an error if not.
Output from above could be:
-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 1e -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 53 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 68 -- -- -- -- -- -- -- -- -- -- -- -- -- -- 77 -- -- -- -- -- -- -- --
Notice that I²C addresses are a bit peculiar.
The address itself is shifted 1 bit left and the last (LSB) bit indicates read or write. So - if looking at the above table:
0x1e = 30 = 0b00011110
0b00011110 << 1 = 60 = 0x3c
So for use with the HAL_I2C commands, shift the address left by one bit. The HAL library will control the read/write bit.