Difference between revisions of "STM32 Electronic speed controller (ESC)"
| Line 67: | Line 67: | ||
| 0.4 | | 0.4 | ||
| 32 | | 32 | ||
| + | |} | ||
== Miscellaneous documentation == | == Miscellaneous documentation == | ||
Revision as of 02:56, 19 May 2022
Electronic speed controller (ESC) is a device which can control a Brushless DC electric motor. This page is meant as a place to write down research notes and it is most definitely a work in progress.
Control
The first ESCs were typically controlled by applying a PWM signal to a pin. Since then many other both analogue and digital approaches have been developed. This section list some of these along with benefits and drawbacks.
Pulse width modulation (PWM)
To be added
SPI
To be added
USB
To be added
MCU
The choice of the optimal MCU is somewhat complex. The following input/output is necessary:
- USB (DP/DM)
- SPI Slave (CLK, MOSI, MISO and CS)
- SPI Master (CLK, MOSI, MISO and CS for flash storage)
- SWD (CLK, DIO)
- UART (RX, TX for debugging)
- 3 x Analog In for current measurement
- 3 x PWM capable high-side outputs
- 3 x low side outputs
- 3 x interrupt capable inputs for zero crossing detection
Experimentally trying to do this on an STM32F411 (of Black Pill fame) result in this:
In other words, the 48 pin STM32F411CE is quite sufficient for this purpose.
MOSFET Half Bridge Driver
To be added
Current Sensing
It is important to be able to measure the current running through the motor coil. Technically it would probably be sufficient to measure the overall current but another approach would be to measure each of the 3 coils.
In principle there are two ways to measure current. The basic one is to run the current through a shunt resistor and then measure the voltage drop across that resistor. More advanced current sensors based on hall effect are available. The benefit of the hall effect sensors is a much lower resistance (and thus voltage drop and energy wasted) but they are pricey.
If we are designing towards 80 amps and use a 0.005 Ohm shunt resistor we get the following values
| Current (A) | Voltage (V) | Power (W) |
|---|---|---|
| 1 | 0.005 | 0.005 |
| 10 | 0.05 | 0.5 |
| 80 | 0.4 | 32 |