Difference between revisions of "LEDCtl (WS2812b LED Controller)"
Jump to navigation
Jump to search
| Line 58: | Line 58: | ||
| 2 | | 2 | ||
| 0-99 | | 0-99 | ||
| − | | "Width" of a zero | + | | "Width" of a zero (percentage) |
|- | |- | ||
| 3 | | 3 | ||
| 0-99 | | 0-99 | ||
| − | | "Width of a one | + | | "Width of a one (percentage) |
|} | |} | ||
Revision as of 03:08, 26 December 2020
LED strips and panels based on some form of the WS2812 RGB LEDs have gained an enormous popularity the past couple of years with the price of the individual LEDs dropping well below 10 cent each. These LEDS contain 3 individual LEDs: one red, one green and one blue and the intensity of each of these can be set at 256 different levels.
Hayes Like Serial Interface
To control the attached LEDs a simple serial interface is used.
AT Commands
| Command | Parameters | Example | Response | Description |
|---|---|---|---|---|
| &F | AT&F | OK | Factory reset | |
| ATLsnnn=rrrgggbbb | s=string nnn=led rrr=3 digit value |
ATL0000=010010010 | Set a specific led on a specific string to a specific value | |
| Sx=y | y = value | ATS0=64 | OK | Set register to a certain value. Example will set register 0 to a value of 64 |
| Z | ATZ | OK | Reset device |
S Registers
| Register | Valid values | Description |
|---|---|---|
| 0 | 0-999 | LEDs on string 0 |
| 1 | 0-999 | LEDs on string 1 |
| 2 | 0-99 | "Width" of a zero (percentage) |
| 3 | 0-99 | "Width of a one (percentage) |