Difference between revisions of "STM32 Memory Map"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
[[Category:C]][[Category:STM32 Development]][[Category:Embedded]][[Category:Work in progress]][[Category:STM32]]{{metadesc|Understanding STM32 Memory Map/Layout Details}} | [[Category:C]][[Category:STM32 Development]][[Category:Embedded]][[Category:Work in progress]][[Category:STM32]]{{metadesc|Understanding STM32 Memory Map/Layout Details}} | ||
[[STM32]] [[MCU]]s all (?) use the following memory map to some degree. There are minor differences so always check the relevant datasheet for the specific [[MCU]] being used. | [[STM32]] [[MCU]]s all (?) use the following memory map to some degree. There are minor differences so always check the relevant datasheet for the specific [[MCU]] being used. | ||
| + | |||
| + | == Block Diagram --== | ||
| + | |||
| + | <div class="res-img"> | ||
| + | |||
| + | [[File:STM32F4xx Memory Map.png|1600px]] | ||
| + | </div> | ||
| + | |||
| + | == Memory Map == | ||
<div class="res-img"> | <div class="res-img"> | ||
| Line 6: | Line 15: | ||
</div> | </div> | ||
| − | The most interesting bit is the detail in the lower left corner specifying the two first blocks of memory | + | The most interesting bit is the detail in the lower left corner specifying the two first blocks of memory. |
| + | |||
| + | == Memory Details == | ||
<div class="res-img"> | <div class="res-img"> | ||
Revision as of 05:39, 1 September 2024
STM32 MCUs all (?) use the following memory map to some degree. There are minor differences so always check the relevant datasheet for the specific MCU being used.
Block Diagram --
Memory Map
The most interesting bit is the detail in the lower left corner specifying the two first blocks of memory.
Memory Details
Of these, the most interesting for a new developer are:
- Flash - 0x8000000
This is where you upload your application.
- RAM - 0x20000000
This is where dynamic variables are allocated.
All internal peripherals are controlled through registers - each with a specific address. But if using HAL it is not necessary to know these addresses.