Difference between revisions of "Colibri Dev"

Latest revision as of 07:57, 15 June 2023

Colibri Dev is a prototyping board for the Colibri system, when simple test are needed before making proper PCBs or when a simple one-off is all that is needed.

It has power and GND rails, plus plenty of pads on both sides with some pads having vias between the front and back layer.

There are footprints wired to I2C for;

MCP4725 - 12bit D/A converter
PCA9557 - 8bit I/O expander
ADS1115IDGS - 16 bit A/D converter
24LC16 - Eeprom

All the colibri pins from the M.2 connector are available on extra large pads;

I2C - SDA, SCL
SPI - MOSI, MISO, SCLK, CS1, CS2, CS3
USB
Programming/Debug - SWDIO, SWCLK
Power - 3.3V, 5V, 12V and Vin (anything from 6-60VDC or 7-36VAC)
Screw Terminals - a, b, c, d
Misc - RESET, LED1

Documentation

@@ Line 1: / Line 1: @@
+[[Category:Colibri]]{{metadesc|Colibri Dev module}}
+[[File:Colibri dev-1.jpg|180px|thumb]][[File:Colibri dev-2.jpg|180px|thumb]]
+Colibri Dev is a prototyping board for the Colibri system, when simple test are needed before making proper PCBs or when a simple one-off is all that is needed.
-Colibri Dev is a board to do experiments with the Colibri I/O system, or to simply make one-off expansion boards that may be needed for a single project.
+It has power and GND rails, plus plenty of pads on both sides with some pads having vias between the front and back layer.
-Power; The 3.3V are present as rails on the two long edges, the 5V and 12V are available on pads.
+There are footprints wired to I2C for;
+* MCP4725 - 12bit D/A converter
+* PCA9557 - 8bit I/O expander
+* ADS1115IDGS - 16 bit A/D converter
+* 24LC16 - Eeprom
-SPI; The SPI is available on special pads
-I2C; The I2C is available on special pads.
+All the colibri pins from the M.2 connector are available on extra large pads;
+* I2C - SDA, SCL
+* SPI - MOSI, MISO, SCLK, CS1, CS2, CS3
-== Special Pads ==
+* USB
-The special pads are 1x1mm and has the signals from the M.2 connector that is used in the Colibri system, primarily the SPI and I2C busses.
+* Programming/Debug - SWDIO, SWCLK
+* Power - 3.3V, 5V, 12V and Vin (anything from 6-60VDC or 7-36VAC)
+* Screw Terminals - a, b, c, d
+* Misc - RESET, LED1
 == Documentation ==
-[[:File:colibri_dev-RevA-schematics.pdf]]
+* [[:File:colibri_dev-RevA-schematics.pdf]]
+* [[:File:colibri_dev-RevA-pcb.pdf]]
-== PCB ==
-[[:File:colibri_dev-RevA-pcb.pdf]]

Difference between revisions of "Colibri Dev"

Latest revision as of 07:57, 15 June 2023

Documentation

Navigation menu

Search