Difference between revisions of "STM32 Built-in Bootloader"
imported>Lth (Created page with "Category:STM32 All STM32 devices have a pin labelled Boot0 which serves one purpose only. If left dangling or tied to GND the device will boot normally, but i...") |
|||
| (5 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | [[Category:STM32]] | + | [[Category:STM32]][[Category:STM32 Documentation]]{{metadesc|Information about the STM32 built-in bootloader/system memory}} |
| − | All [[STM32]] | + | All [[STM32]] [[MCU]]s have a built-in bootloader which is stored in the internal boot ROM (system memory). This boot ROM is programmed by [[ST]] during manufacturing and can not be altered. The main purpose of the boot ROM is to allow applications to be written to the internal flash memory. |
| + | |||
| + | Depending on the exact [[STM32]] device family, the internal boot ROM will allow flashing using a variety of different methods: | ||
| + | |||
| + | * USART | ||
| + | * CAN | ||
| + | * USB | ||
| + | * I2C | ||
| + | * SPI | ||
| + | |||
| + | There are a number of different bootloader activation patterns described by [[ST]] in the reference documentation and in order to fully understand the operation of a specific [[STM32]] microcontroller, it is necessary to consult that documentation. In most cases however, the [[Boot0]] pin is the most interesting one. If left dangling or tied to [[GND]] the device will boot normally, but if pulled high the device will bootstrap from the internal boot ROM. | ||
| + | |||
| + | == Further Reading == | ||
| + | |||
| + | The various boot modes of [[STM32]] microcontrollers is described in details in [https://www.st.com/resource/en/application_note/cd00167594-stm32-microcontroller-system-memory-boot-mode-stmicroelectronics.pdf AN2606 Application note - STM32 microcontroller system memory boot mode]. | ||
Latest revision as of 01:40, 6 August 2022
All STM32 MCUs have a built-in bootloader which is stored in the internal boot ROM (system memory). This boot ROM is programmed by ST during manufacturing and can not be altered. The main purpose of the boot ROM is to allow applications to be written to the internal flash memory.
Depending on the exact STM32 device family, the internal boot ROM will allow flashing using a variety of different methods:
- USART
- CAN
- USB
- I2C
- SPI
There are a number of different bootloader activation patterns described by ST in the reference documentation and in order to fully understand the operation of a specific STM32 microcontroller, it is necessary to consult that documentation. In most cases however, the Boot0 pin is the most interesting one. If left dangling or tied to GND the device will boot normally, but if pulled high the device will bootstrap from the internal boot ROM.
Further Reading
The various boot modes of STM32 microcontrollers is described in details in AN2606 Application note - STM32 microcontroller system memory boot mode.