Difference between revisions of "MPR121 Proximity Capacitive Touch Sensor Controller"
Jump to navigation
Jump to search
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Category:Components]][[Category:I²C]][[Category:Work in progress]]{{metadesc|MPR121 Proximity Capacitive Touch Controller}} | [[Category:Components]][[Category:I²C]][[Category:Work in progress]]{{metadesc|MPR121 Proximity Capacitive Touch Controller}} | ||
| − | [[File: | + | [[File:MPR121 Keypad rev. b.jpg|250px|thumb|Keypad Matrix]] |
The MPR121 is a [[I²C]] device which can be used to implement touch keys. It can also function as a [[GPIO]] extender and can be used to drive [[LED]]s. | The MPR121 is a [[I²C]] device which can be used to implement touch keys. It can also function as a [[GPIO]] extender and can be used to drive [[LED]]s. | ||
| Line 17: | Line 17: | ||
[[#Revision a|Rev. a]] was a bit of a rush job and I managed to get one thing fundamentally wrong. For some bizarre reason, the [[MPR121]] can supply 17 mA on the LED pins but it can only sink about 1.5 mA, so LED's should not be active low on these pins but active high. Also, by rearranging the rows and columns, the actual routing got quite a lot neater. | [[#Revision a|Rev. a]] was a bit of a rush job and I managed to get one thing fundamentally wrong. For some bizarre reason, the [[MPR121]] can supply 17 mA on the LED pins but it can only sink about 1.5 mA, so LED's should not be active low on these pins but active high. Also, by rearranging the rows and columns, the actual routing got quite a lot neater. | ||
| − | |||
<div class="res-img"> | <div class="res-img"> | ||
[[File:MPR121 Keypad rev. b schematics.svg|2400px]] | [[File:MPR121 Keypad rev. b schematics.svg|2400px]] | ||
| Line 28: | Line 27: | ||
File:Touch Keyboard - bot.jpg | File:Touch Keyboard - bot.jpg | ||
File:Touch Keyboard - detail.jpg | File:Touch Keyboard - detail.jpg | ||
| + | File:4 pcs MPR121 keypad.jpg | ||
| + | File:MPR121 components.jpg | ||
| + | File:MPR121 Keypad rev. b - bot.jpg | ||
| + | File:MPR121 Keypad rev. b.jpg | ||
| + | File:MPR121 rev. b hooked up.jpg | ||
</gallery> | </gallery> | ||
Revision as of 08:11, 20 June 2023
The MPR121 is a I²C device which can be used to implement touch keys. It can also function as a GPIO extender and can be used to drive LEDs.
Test Board
In order to try out the MPR121 I created a quick keypad.
Schematics
Revision a
Revision b
Rev. a was a bit of a rush job and I managed to get one thing fundamentally wrong. For some bizarre reason, the MPR121 can supply 17 mA on the LED pins but it can only sink about 1.5 mA, so LED's should not be active low on these pins but active high. Also, by rearranging the rows and columns, the actual routing got quite a lot neater.
